Please follow the Wiring diagram correctly when connecting 2 Way switches. It is possible to place a load on each switch. You only need to ensure that if a Load is connected to any one of the terminals on 1 switch the corresponding load on the second switch is kept empty unless both Gangs intend to be used as 1 Way instead of 2 Ways.
When the switches are wired correctly, the switches should automatically recognise which buttons will be 2 Way. If it does not occur, you can pair the buttons and un-pair them if required. The following procedures are as follows:
Pairing 2 buttons:
- With the lights off, press and hold the light switch on the master button (Master button refers to the button where the load is connected) until you see a flashing blue light and then let go.
- Within a 10 second window, press the corresponding button on the second switch.
Unpairing buttons:
- With the lights off, press and hold the light switch on the master button (The slave button refers to the button where no load is connected) until you see a flashing blue light and then let go.
- While the blue light is flashing, press and hold the button again until the flashing blue light slows down and stops, removing the two-way link.
Please note that when making the switches work two way, L1 will work with L1, L2 with L2 and L3 with L3. It is possible to connect 2 X 2 Gang 2 Way switches and make two buttons work as two way, and the remaining buttons work as one way each. I LumoS 2 Way Touch Light switches can only work with another 2 Way Touch light. They are not compatible with Mechanical Switches
